HP 8360 - Page 321

Table S-l. HP 8360 SCPl COMMAND SUMMARY (continued)
Command Parameters Parameter Type1 Allowed Values
[n] is 1 to 5, 1 is the default
MARKer[n]
:AMPLitude
[:STATe]
state Boolean ON/OFF]1 10
:VALue amp marker
extended numeric +10 to
depth
-1ODB]MAXimum]MINimum
:AOFF
:DELTa? difference between
numeric
<num>,<num> 1 to 5
two markers
:FREQuency marker frequency
extended numeric specified freq range
or MAXimum]MINimum
:MODE marker mode
discrete FREQuencylDELTa
:REFerence delta marker ref
numeric
1 to 5
[:STATe] state
Boolean ON]OFF(l(O
MODulation
:OUTPut
:SOURce
output mod source discrete
AMIFM
:STATe
output mod state Boolean
ON]OFF]l]O
:STATe? state
Boolean
ONJOFFJlJO
POWer
:ALC
:BANDwidth ALC bwidth
extended numeric <num>[freq suffix]
or MAXimumlMINimum
:AUTO
bwidth selection Boolean
ON]OFF]l]O
:CFACtor
coupling factor
extended numeric 0 to -9O[DB] or
MAXimum]MINimum]UP]DOWN
:SOURce leveling point
discrete
INTernallDIODelPMETerlMMHead
[:STATe]
state
Boolean ON]OFF]l]O
:AMPLifier
:STATE
Boolean
ONJOFFJlJO
:AUTO
Boolean ON]OFF(l]O
:ATTenuation atten setting
extended numeric
0 to 90 [DB] or
MAXimum]MINimum]UP]DOWN
:AUTO
coupled atten
Boolean
ON(OFF(l(0
:CENTer power sweep
extended numeric
specified power range or
center
MAXimum]MINimum]UP]DOWN
[:LEVel]
output level
extended numeric
specified power range or
MAXimum]MINimum]UP]DOWN
HP 8360
User’s Handbook
Operating and Programming Reference S-23