*RST state is AUTO.
l
LIST[:POWer]:CORRection
(<num>[DB]IMAXimumlMINimum~l*801
l
LISTC:POWer]:CORRection?
Sets and queries the list of correction levels that correspond to each
of the frequencies entered using the LIST:FREQ command. The
attenuator is not allowed to change during the list execution. The
number of parameters can be from 1 to 801.
After
*RST,
the value is 0.
l
LIST[:POWer]:CORRection:POINts?
[MAXimum|MINimum]
Returns the number of correction points that have been entered into
the list array. After
*RST
returns a 1.
l
LIST:TRIGger:SOURce
IMMediatelBUSlEXTernal
l
LIST:TRIGger:SOURce?
Sets and queries the list point-to-point trigger source when in the
automatic list mode. See
LIST:MODE
and
1NIT:CONT
for more details.
*RST state is IMMediate.
l
MARKerh]:AMPLitude[:STATe]
ONIOFF
Ill0
l
MARKerh]:AMPLitude[:STATel?
Sets and queries the amplitude marker on/off switch. While [n] may
be used, there is really only a single switch for all the markers.
*RST value is OFF.
l
MARKer[n]:AMPLitude:VALue
<num>[DB]
IMAXimum
I
MINimum
l
MARKer[n]:AMPLitude:VALue? [MAXimum|MINimum]
Sets and queries the value of the amplitude marker. While [n] may
be used, there is really only a single value for all the markers.
*RST
value is 2
dB.
l
MARKerCn]:AOFF
Sets all the markers to OFF at once. While [n] may be used, there is
really only a single switch for all the markers.
l
MARKer[n]:DELTa?
<num>,<num>
This query returns the difference in frequency between the two
specified marker numbers.
l
MARKer[n]:FREQuency
<mm>
[freq
suffix]lMAXimumiMINimum
l
MARKer[n]:FREQuency? [MAXimum|MINimum]
Sets and queries the specified marker frequency (marker number
one is the default if [n] is not specified). The value is interpreted
differently based on the value of the marker mode.
S-40
Operating and Programming Reference
HP 8360
User’s Handbook
To Next Page
