HP 8360 - Page 346

command to set the switch will cause ROSC:SOUR:AUTO OFF to
be done also. The *RST value is automatically determined.
l ROSCillator:SOURce:AUTO ONlOFFlllO
a ROSCillator:SOURce:AUTO?
Sets and queries the automatic reference selection switch.
The *RST value is 1.
l STATus:OPERation:CONDition?
Queries the Standard Operation Condition register.
l STATus:OPERation:ENABle <mua>
l STATus:OPERation:ENABle?
Sets and queries the Standard Operation Enable register.
The STATus:PRESet value is 0.
l STATus:OPERation[:EVENt]?
Queries the Standard Operation Event Register. This is a destructive
read.
l STATus:OPERation:NTRansition Cnum>
l STATus:OPERation:NTRansition?
Sets and queries the Standard Operation Negative Transition Filter.
The STATus:PRESet value is 0.
l STATus:OPERation:PTRansition <rum>
l STATus:OPERation:PTRansition?
Sets and queries the Standard Operation Positive Transition Filter.
After STATus:PRESet, all used bits are set, to 1’s.
l STATUS:PRESet
This command presets the following enable and transition registers:
MSIB, OPERation, QUEStionable, and SRECeiver.
ENABle
Is set to all 0s.
NTRansition
Is set to all 0s.
PTRansition
All bits used are set to 1s. Unused bits remain OS.
l STATus:QUEStionable:CONDition?
Queries the Data Questionable Condition Register.
l STATus:QUEStionable:ENABle <mm>
l STATus:QUEStionable:ENABle?
Sets and queries the Data Questionable SRQ Enable register.
The STATus:PRESet value is 0.
S-48 Operating and Programming Reference
HP 8360
User’s Handbook