HP 8360 - Page 372

Sweep Mode Itamp
Programming Codes
SCPI:
FREQuency:MODE SWEep
SWEep[:FREQ
uency]:GENeration
ANALog
Analyzer: NONE
See Also
CONNECTORS, [CONT), Manual Sweep,(SINGLE),
“Programming Typical Measurements,” in Chapter 1.
Sweep Mode Step
Function Group
Menu Map
Description
Programming Codes
See Also
SWEEP
7
This softkey activates the stepped frequency step mode. In this
mode, the synthesizer steps from the start frequency to the stop
frequency, by the designated frequency step size. Manual, continuous,
and single sweeps can be performed in this mode. An asterisk next to
the key label indicates that this feature is active.
SCPI:
FREQuency:MODE SWEep
SWEep[:FREQ
uency]:GENeration
STEPped
Analyzer: NONE
[E), Manual Sweep,(SINGLE), Step Swp Menu
“Using Step Sweep,” in Chapter 1.
S-74 Operating and Programming Reference
HP 8360
User’s Handbook