HP 8360 - Page 483

menu, A-11
select auto, A-9
select high, A-10
select low, A-10
ALC bandwidth selection, l-50
ALC disabled
theory of, A-8
ALC leveling
internal, L-3
mm-wave module, L-3
normal, L-l
power meter, L-4
search, L-2
ALC menu, A-2-4
ALC off, L-l
ALC off mode, l-32
ALC open loop, L-l
ALC search mode, l-32
align output filter, A-26, P-l
alternate registers, A-12
altitude pressure, 3-9
always calibrate sweep span, S-74
AM
ALC off mode, D-l
deep, D-l, M-15
depth, I-l
exponentially scaled, A-14, A-18
linearly scaled, A-15, A-18
rate, I-l, M-15
AM bandwidth calibration, M-16
AM/FM output connector, C-4
AM input connector, C-4
AM output
rear panel, M-11
amplitude markers, 1-14, A-17
amplitude modulation, M-13
display depth, M-9
greater depth, D-l
internal, I-l
softkeys, A-13
amplitude modulation bandwidth calibration, A-12-13
amplitude modulation on/off, A-14-16, A-18-19
AM waveform
noise, I-2
ramp, I-2
sine, I-3, I-6
square, I-3
triangle, I-4, I-7
analog sweep mode, S-73
analyzer compatibility, P-12
analyzer language, P-12
analyzer programming language, A-19
angle brackets, l-64
apply flatness correction, F-l 1
arrow keys, A-21
Index-2