example program
flatness correction,
l-97
HP-IB check,
l-88
local lockout,
l-89
looping and synchronization, l-95
setting up a sweep, l-90
synchronous sweep,
l-96
use of queries,
l-92
use of save/recall,
l-93
example programs,
l-86-100
examples, equipment used,
l-2
examples, simple program messages,
l-72
example, stimulus response program, l-76
extended numeric parameters
discussed in detail, l-83
explained briefly,
l-74
extenders
HP-IB,
C-9
EXTernal
trigger source defined, l-113
external ALC BNC, L-2,
L-4
external ALC connector,
C-5
external AM, A-16
external detector calibration,
E-5
external detector leveling,
L-2
external frequency standard, T-l
external leveling,
l-23-29
coupling factor, C-13
detector calibration, E-5
low output, l-26
theory of, A-7
with detectors, couplers, or splitters,
l-23-26
with power meters,
l-27
with source modules,
l-28
external power meter range, P-22
external pulse modulation, P-17
external trigger
frequency list, L-8
external trigger, stepped sweep,
S-70
external trigger, sweep mode,
S-63
F
factor, coupling, C-13
factory preset, P-9
factory-set interface addresses, 3-7
fan filter, clean, 4-5
fastest sweep-retrace cycle,
S-62
fault information, F-l
fault information 1, F-2
fault information 2, F-3
fault menu, F-l
fault status
clear,
C-2
feature status,
D-6
filter
Index-6
To Next Page
