HP 8360 - Page 492

front panel operation, L-9
full selftest, S-58
full selftest command, S-17
fullusr cal, F-19
function locked out message, 2a-3
fuse part numbers, 4-4
fuse, replace, 4-4
fuse selection, 3-3
G global dwell
list array, G-l
global offset
list array, G-l
GP-IB
analyzer language, P-12
CIIL language, P-12
printer address, P- 10
SCPI programming, P-13
trigger, frequency list, L-8
GP-IB address
changes to, 3-8
factory-set, 3-7
power meter, M-8
GPIB address
synthesizer, A- 1, E- 1
GP-IB check, example program, l-88
GP-IB connector, C-8
GP-IB control functions, H-l
GP-IB trigger
stepped sweep mode, S-70
sweep mode, S-63
grounding pin, 3-4
Group Execute Trigger, 1-113
group execute trigger command, S-17
H
HP 437B
detector calibration, E-5
programming address, M-8
HP 437B, flatness correction measure all, M-7
HP 437B, measure correction, M-7, M-8
HP 437B measure correction functions, M-27
HP 8340
status register, A-19
HP 8340/41 system convert to HP 8360 system, 3-19
HP 83550-series interface connector, C-10
HP 83550 series system connections, 3-22
HP 8360 as controller, 3-7
HP 8510 system connections, 3-21
HP 8516A interface connector, C-6
HP 8757C/E system connections, 3-21
HP 8970B system connections, 3-22
HP-IB
analyzer language, P-12
CIIL language, P-12
Index- 11