197
To do... Use the command... Remarks
Create an MSDP peer connection
peer peer-address connect-interface
interface-type interface-number
Required
No MSDP peer connection
created by default
NOTE:
If an interface of the router is shared by an MSDP peer and a BGP/MBGP peer at the same time, HP
recommends you to use the IP address of the BGP/MBGP peer as the IP address of the for the MSDP
peer.
Configuring a static RPF peer
Configuring static RPF peers avoids RPF check of SA messages.
Follow these steps to configure a static RPF peer:
To do... Use the command... Remarks
Enter system view system-view —
Enter public network MSDP view or
VPN instance MSDP view
msdp [ vpn-instance vpn-
instance-name ]
—
Configure a static RPF peer
static-rpf-peer peer-address [
rp-policy ip-prefix-name ]
Required
No static RPF peer configured by
default
NOTE:
If only one MSDP peer is configured on a router, this MSDP will be registered as a static RPF peer.
Configuring an MSDP peer connection
Configuration prerequisites
Before you configure MSDP peer connection, complete the following tasks:
• Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer
• Configure basic functions of MSDP
• Determine the description information of MSDP peers
• Determine the name of an MSDP mesh group
• Determine the MSDP peer connection retry interval
Configuring MSDP peer description
With the MSDP peer description information, the administrator can easily distinguish different MSDP
peers to better manage MSDP peers.
Follow these steps to configure description for an MSDP peer:
To Next Page
Loading...
Need help?
General
