131
NOTE:
For more information about the configuration of other timers in PIM-DM, see “Configuring PIM
common tim
ers.”
Configuring PIM-SM
PIM-SM configuration task list
Complete these tasks to configure PIM-SM:
Task Remarks
Enabling PIM-SM Required
Configuring an RP
Configuring a static RP Optional
Configuring a C-RP Optional
Enabling auto-RP Optional
Configuring C-RP timers globally Optional
Configuring a BSR
Configuring a C-BSR Optional
Configuring a PIM domain border Optional
Configuring global C-BSR parameters Optional
Configuring C-BSR timers Optional
Disabling BSM semantic fragmentation Optional
Configuring administrative scoping
Enabling administrative scoping Optional
Configuring an admin-scope zone boundary Optional
Configuring C-BSRs for each admin-scope zone
and the global-scope zone
Optional
Configuring multicast source registration Optional
Disabling SPT switchover Optional
Configuring PIM common features Optional
Configuration prerequisites
Before you configure PIM-SM, complete the following tasks:
• Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
• Determine the IP address of a static RP and the ACL defining the range of multicast groups to be
served by the static RP.
• Determine the C-RP priority and the ACL defining the range of multicast groups to be served by
each C-RP.
• Determine the legal C-RP address range and the ACL defining the range of multicast groups to be
served.
• Determine the C-RP-Adv interval.
To Next Page
Loading...
Need help?
General
