249
Configuring aging timers for dynamic ports globally
Follow these steps to configure aging timers for dynamic ports globally:
To do... Use the command... Remarks
Enter system view system-view —
Enter MLD snooping view
mld-snooping —
Set the aging timer for dynamic
router ports
router-aging-time interval
Optional
260 seconds by default
Set the aging timer for dynamic
member ports
host-aging-time interval
Optional
260 seconds by default
Configuring aging timers for dynamic ports in a VLAN
Follow these steps to configure aging timers for dynamic ports in a VLAN:
To do... Use the command... Remarks
Enter system view system-view —
Enter VLAN view vlan vlan-id —
Set the aging timer for dynamic
router ports
mld-snooping router-aging-time
interval
Optional
260 seconds by default
Set the aging timer for dynamic
member ports
mld-snooping host-aging-time
interval
Optional
260 seconds by default
Configuring static ports
If all hosts attached to a port are interested in the IPv6 multicast data addressed to a particular IPv6
multicast group, configure the port as a static member port for that IPv6 multicast group.
You can configure a port of a switch to be a static router port, through which the switch can forward all
IPv6 multicast data that it received.
Follow these steps to configure static ports:
To do... Use the command... Remarks
Enter system view system-view —
Enter Ethernet interface view,
Layer 2 aggregate interface view,
or port group view
interface interface-type interface-
number
Required
Use either approach
port-group manual port-group-
name
Configure the port as a static
member port
mld-snooping static-group ipv6-
group-address [ source-ip ipv6-
source-address ] vlan vlan-id
Required
No static member ports exist by
default
Configure the port as a static
router port
mld-snooping static-router-port
vlan vlan-id
Required
No static router ports by exist
default
To Next Page
Loading...
Need help?
General
