182
Total 1 RP
Total 1 RP matched
00001. RP Address: 1.1.1.1
MID: 0, Flags: 0x2100000:0
Uptime: 00:05:12
RPF interface: Vlan-interface103
List of 2 DF interfaces:
1: Vlan-interface300
2: Vlan-interface400
PIM-SSM configuration example
Network requirements
• As shown in Figure 53, receivers receive VOD information through multicast. The receiver groups
of different organizations form stub networks, and one or more receiver hosts exist in each stub
network. The entire PIM domain operates in the SSM mode.
• Host A and Host C are multicast receivers in two stub networks.
• Switch D connects to the network that comprises the multicast source (Source) through VLAN-
interface 300.
• Switch A connects to stub network N1 through VLAN-interface 100 and to Switch D and Switch E
through VLAN-interface 101 and VLAN-interface 102 respectively.
• Switch B and Switch C connect to stub network N2 through their respective VLAN-interface 200
and to Switch E through VLAN-interface 103 and VLAN-interface 104 respectively.
• Switch E connects to Switch A, Switch B, Switch C and Switch D.
• The SSM group range is 232.1.1.0/24.
• IGMPv3 will run between Switch A and N1 and between Switch B/Switch C and N2.
To Next Page
Loading...
