HP A5500 SI Switch Series User Manual

411
Configuring inbound IPv6 MBGP route filtering
Follow these steps to configure IPv6 MBGP inbound route filtering:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number
—
Enter IPv6 MBGP address family
view
ipv6-family multicast
—
Configure inbound route filtering
filter-policy { acl6-number | ipv6-
prefix ipv6-prefix-name } import
Use any of the commands
By default, advertised routes are
not filtered.
Configure a filtering policy as
needed.
If several filtering policies are
configured, they are applied in
the following sequence:
• filter-policy import
• peer filter-policy import
• peer as-path-acl import
• peer ip-prefix import
• peer route-policy import
A filter policy can be applied only
after the previous one is passed;
routing information can be
received only after passing all the
filter policies configured.
Apply a routing policy to routes
from a peer/peer group
peer { ipv6-group-name | ipv6-
address } route-policy route-
policy-name import
Specify an IPv6 ACL to filter
routes from a peer/peer group
peer { ipv6-group-name | ipv6-
address } filter-policy acl6-number
import
Specify an AS path ACL to filter
IPv6 BGP routing information from
a peer/peer group
peer { ipv6-group-name | ipv6-
address } as-path-acl as-path-acl-
number import
Specify an IPv6 prefix list to filter
routes from a peer/peer group
peer { ipv6-group-name | ipv6-
address } ipv6-prefix ipv6-prefix-
name import
Specify the upper limit of prefixes
that can be imported from a
peer/peer group
peer { ipv6-group-name | ipv6-
address } route-limit limit [
percentage ]
Optional
The number is unlimited by
default.
NOTE:
A
peer can have an inbound route filtering policy that is different from the policy of the peer group that
it belongs to. That is, peer group members can have different inbound route filtering policies.
Configuring IPv6 MBGP route dampening
Follow these steps to configure IPv6 MBGP route dampening parameters:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —
Enter IPv6 MBGP address family
view
ipv6-family multicast —

HP A5500 SI Switch Series Specifications

General

Layer Support	Layer 2 and Layer 3
MAC Address Table	16K entries
Routing Protocol	RIP, OSPF, BGP, IS-IS
Management	Web, CLI, SNMP
Input Voltage	100-240 V AC
Operating Temperature	0°C to 45°C
Ports	48 x 10/100/1000 ports, 4 x 10-Gigabit SFP+ ports
Dimensions	440 x 430 x 44 mm
Weight	5.5 kg
Operating Humidity	10% to 95% (non-condensing)