397
Configure OSPF on the switches in the IPv6 BIDIR-PIM domain to ensure network-layer reachability
among them (details not shown).
2. Enable IPv6 multicast routing, IPv6 PIM-SM, IPv6 BIDIR-PIM, and MLD.
# On Switch A, enable IPv6 multicast routing, enable IPv6 PIM-SM on each interface, and enable IPv6
BIDIR-PIM.
<SwitchA> system-view
[SwitchA] multicast ipv6 routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] pim ipv6 sm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim ipv6 sm
[SwitchA-Vlan-interface101] quit
[SwitchA] pim ipv6
[SwitchA-pim6] bidir-pim enable
[SwitchA-pim6] quit
# On Switch B, enable IPv6 multicast routing, enable IPv6 PIM-SM on each interface, enable MLD on
VLAN interface 200, and enable IPv6 BIDIR-PIM.
<SwitchB> system-view
[SwitchB] multicast ipv6 routing-enable
[SwitchB] interface vlan-interface 200
[SwitchB-Vlan-interface200] mld enable
[SwitchB-Vlan-interface200] pim ipv6 sm
[SwitchB-Vlan-interface200] quit
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] pim ipv6 sm
[SwitchB-Vlan-interface101] quit
[SwitchB] interface vlan-interface 102
[SwitchB-Vlan-interface102] pim ipv6 sm
[SwitchB-Vlan-interface102] quit
[SwitchB] pim ipv6
[SwitchB-pim6] bidir-pim enable
[SwitchB-pim6] quit
# On Switch C, enable IPv6 multicast routing, enable IPv6 PIM-SM on each interface, and enable IPv6
BIDIR-PIM.
<SwitchC> system-view
[SwitchC] multicast ipv6 routing-enable
[SwitchC] interface vlan-interface 102
[SwitchC-Vlan-interface102] pim ipv6 sm
[SwitchC-Vlan-interface102] quit
[SwitchC] interface vlan-interface 103
[SwitchC-Vlan-interface103] pim ipv6 sm
[SwitchC-Vlan-interface103] quit
[SwitchC] interface loopback 0
[SwitchC-LoopBack0] pim ipv6 sm
[SwitchC-LoopBack0] quit
[SwitchC] pim ipv6
To Next Page
Loading...
Need help?
General
