HP Compaq nc6220 User Manual

Drives
Hardware and Software Guide 5–14
Removing an Optical Disc (Without Power)
If power is unavailable:
1. Insert the end of a paper clip into the release access in the
front bezel of the drive.
2. Press gently on the paper clip until the media tray is released,
and then pull out the tray until it is fully extended.
3. Remove the disc from the tray by gently pressing down on the
spindle while lifting the outer edges of the disc. Handle the
disc by the edges, not the flat surfaces. If the media tray is not
fully extended, tilt the disc as you remove it. To protect the
disc, place it in a protective case
4. Close the media tray.

HP Compaq nc6220 Specifications

General

Display	14.1-inch TFT
Maximum Memory	4 GB
Hard Drive Interface	ATA-100
Graphics	Intel Graphics Media Accelerator 900
Operating System	Windows XP Professional
Battery Life	Up to 4 hours
Processor	Intel Pentium M
Display Resolution	1024 x 768
Storage	40 GB
Networking	10/100/1000 Ethernet, 802.11b/g Wi-Fi
Ports	3 x USB 2.0, VGA, RJ-11, RJ-45, headphone/microphone jacks
Optical Drive	DVD-ROM
RAM	512 MB to 2 GB