Security
Hardware and Software Guide 12–15
Entering DriveLock Passwords
1. Be sure that the hard drive is inserted into the notebook
(not
into an optional docking device or external MultiBay).
2. When prompted for a DriveLock password, type your user
or
master password (using the same kind of keys you used
to
set the password), and then press enter.
✎
After 2 incorrect attempts to enter the password, you must
restart the notebook and try again.
Requiring a Drivelock Password at Restart
You can require that a DriveLock password be entered each time
the notebook is restarted. Enable and disable this feature in
Computer Setup:
1. Shut down the notebook. If you are not sure whether the
notebook is off or in hibernation, turn the notebook on by
pressing the power button, and then shut down the notebook
through the operating system.
2. Be sure that the hard drive is inserted into the notebook
(not
into an optional docking device or external MultiBay).
3. Open Computer Setup by turning on or restarting the
notebook. Press
f10 while the F10 = ROM Based Setup
message is displayed in the lower-left corner of the screen.
❏ To change the language, press f2.
❏ For navigation instructions, press f1.
To Next Page
Loading...
Need help?
General
