MultiBoot
Hardware and Software Guide B–4
Bootable Devices in Computer Setup
The notebook can start up from a USB device or the NIC only if
that device has been enabled for inclusion in MultiBoot.
To enable a device or location for inclusion in MultiBoot:
1. Open Computer Setup by turning on or restarting the
notebook. Press
f10 while the F10 = ROM Based Setup
message is displayed in the lower-left corner of the screen.
❏ To change the language, press f2.
❏ For navigation instructions, press f1.
2. To enable bootable media in USB drives or in drives inserted
into an optional docking device, use the arrow keys to select
the Advanced menu > Device Options. Then select Enable
USB legacy support.
– or –
To enable a NIC, select Security menu > Device security,
and then select Internal network adapter boot.
3. Save your preferences and exit Computer Setup by using the
arrow keys to select File > Save Changes and Exit. Then
follow the instructions on the screen.
Your preferences are set when you exit Computer Setup and take
effect when the notebook restarts.
✎
To connect a NIC to a Preboot eXecution Environment (PXE) or
Remote Program Load (RPL) server during startup without using
MultiBoot, quickly press
f12 when the Network Service Boot
message is displayed in the lower-left corner of the screen.
To Next Page
Loading...
Need help?
General
