HP Compaq nc6220 User Manual

Power
Hardware and Software Guide 2–28
Discharging the Battery Pack
Before you begin a full discharge, disable hibernation.
To disable hibernation:
1. Select Start > Control Panel > Performance and
Maintenance > Power Options
> Hibernate tab.
2. Clear the Enable hibernation check box.
3. Select Apply.
The notebook must remain on while the battery pack is being
discharged. The battery pack can discharge whether or not you
are using the notebook but will discharge faster while the
notebook is in use.
■ If you plan to leave the notebook unattended during the
discharge, save your work before beginning the discharge
procedure.
■ If you use the notebook occasionally during the discharge
procedure and have set energy-saving timeouts, expect the
following performance from your system during the
discharge process:
❏ The monitor will not turn off automatically.
❏ Hard drive speed will not decrease automatically while
the notebook is idle.
❏ System-initiated standby will not occur.

HP Compaq nc6220 Specifications

General

Display	14.1-inch TFT
Maximum Memory	4 GB
Hard Drive Interface	ATA-100
Graphics	Intel Graphics Media Accelerator 900
Operating System	Windows XP Professional
Battery Life	Up to 4 hours
Processor	Intel Pentium M
Display Resolution	1024 x 768
Storage	40 GB
Networking	10/100/1000 Ethernet, 802.11b/g Wi-Fi
Ports	3 x USB 2.0, VGA, RJ-11, RJ-45, headphone/microphone jacks
Optical Drive	DVD-ROM
RAM	512 MB to 2 GB