Computer Setup
Hardware and Software Guide 13–3
Computer Setup Defaults
To return all settings in Computer Setup to the values that were
set at the factory:
1. Open Computer Setup by turning on or restarting the
notebook. Press
f10 while the F10 = ROM Based Setup
message is displayed in the lower-left corner of the screen.
❏ To change the language, press f2.
❏ To view navigation information, press f1.
2. Use the arrow keys to select File > Restore defaults.
3. Select the Restore Defaults check box.
4. To confirm the restoration, press f10.
5. Select File > Save Changes and Exit. Then follow the
instructions on the screen.
When the computer restarts, the factory settings are restored, and
any identification information you may have entered is saved.
✎
Password- and security-related settings are not changed when you
reset the factory default settings.
To Next Page
Loading...
