HP Compaq nc6220 User Manual

USB Devices
Hardware and Software Guide 9–3
USB Legacy Support
You must enable USB legacy support to
■ Use a USB keyboard, mouse, or hub connected to a USB port
on the notebook during startup or in a
non-Windows
application or utility.
■ Boot from an optional external MultiBay.
To enable USB legacy support:
1. Turn on or restart the notebook.
2. Press f10 while the F10 = ROM Based Setup message is
displayed in the lower left corner of the screen.
❏ To change the language, press f2.
❏ For navigation instructions, press f1.
3. Select Advanced > Device Options.
4. Select USB legacy support.
5. To save your preference and exit Computer Setup, select
File
> Save Changes and Exit, and then follow the
instructions on
the screen.

HP Compaq nc6220 Specifications

General

Display	14.1-inch TFT
Maximum Memory	4 GB
Hard Drive Interface	ATA-100
Graphics	Intel Graphics Media Accelerator 900
Operating System	Windows XP Professional
Battery Life	Up to 4 hours
Processor	Intel Pentium M
Display Resolution	1024 x 768
Storage	40 GB
Networking	10/100/1000 Ethernet, 802.11b/g Wi-Fi
Ports	3 x USB 2.0, VGA, RJ-11, RJ-45, headphone/microphone jacks
Optical Drive	DVD-ROM
RAM	512 MB to 2 GB