2. The printhead is designed to be inserted into any of the available slots. Once the printhead is inserted into a
specic slot, it will be set up to work only with that combination of colors. For this reason, it is important to
mark the printhead with its specic color, on the label that comes with it, matching the color of the carriage
slot into which the printhead is to be inserted.
3. Insert the new printhead into its correct slot in the carriage.
CAUTION: Insert the printhead slowly and vertically, straight down. It may be damaged if you insert it too
fast, or at an angle, or if you rotate it as you insert it.
4. Push down as indicated by the arrow shown below.
CAUTION: When installing the new printhead there may be some resistance, so you need to press it down
rmly but smoothly. You should hear a beep and see conrmation on the front-panel display that the
printhead has been inserted. If you have diiculty, see Cannot insert a printhead on page 145.
ENWW Insert a printhead 105
To Next Page
Loading...