To replace the component, reverse the removal procedure.
Removing and replacing an energy pack
Procedure
1.
If installed,
remove the bezel.
2.
Power down the server.
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
5.
Remove the access panel.
6. Disconnect the energy pack cable from the system board.
7. Remove the energy pack.
Removal and replacement procedures
58
To Next Page
Loading...
