To replace the component, reverse the removal procedure.
Removing and replacing a hot-plug power supply
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are
populated with either a component or a blank.
Procedure
1. If installed,
remove the bezel.
2. Power down the server.
3.
Access the product rear panel.
4. Release the power cord from the strain relief strap.
5.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
6. Remove the power supply.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or power supply
blank to cool before touching it.
Removal and replacement procedures 81
To Next Page
Loading...
