HP HPE ProLiant DL325

To replace the component, reverse the removal procedure.
Removing and replacing the energy pack holder
Procedure
1.
If installed,
remove the bezel.
2.
Power down the server.
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
5.
Remove the access panel.
6.
Remove the energy pack.
7. Remove the energy pack holder from the chassis.
Removal and replacement procedures
59