HP HPE ProLiant DL325

To replace the component, reverse the removal procedure.
Removing and replacing the USB 3.0 cable assembly in LFF
Prerequisites
Before you perform this procedure, make sure that you have a T-15 screwdriver available.
Procedure
1.
If installed,
remove the bezel.
2.
Power down the server.
3.
Remove all power:
a.
Disconnect each power cord from the power source
b.
Disconnect each power cord from the server.
4.
Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
5. Remove the access panel.
6. Disconnect the USB
30 cable from the system board.
7. Release the cable from clips.
8. Remove the USB 30 cable assembly.
Removal and replacement procedures
71