To replace the component, reverse the removal procedure.
Removing and replacing a chassis ear
Prerequisites
Before you perform this procedure, make sure that you have T-10 Torx screwdriver available.
Procedure
1.
If installed,
remove the bezel.
2.
Power down the server.
3.
Remove all power:
a.
Disconnect each power cord from the power source
b.
Disconnect each power cord from the server.
4.
Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
5. Remove the chassis ear.
• Right ear
Removal and replacement procedures
64
To Next Page
Loading...
