HP Integrity rx4640 Upgrade Guide

Chapter 1
Overview—Server Upgrade
Common Procedures
12
Common Procedures
The procedures in this section are for removing and replacing server components for the upgrades in this
guide.
Accessing a Rack Mounted Server
The hp Integrity rx4640 Server is designed to be rack mounted. The following procedure explains how to gain
access to your hp Integrity rx4640 Server that is mounted in an approved rack. For rack installation
instructions, review the document titled Installation Guide, Mid-Weight Slide Kit, 5065-7291. This document
can be accessed at: http://www.hp.com/racksolutions.
WARNING Ensure that all anti-tip features (front and rear anti-tip feet installed; adequate
ballast properly placed; and so on) are employed prior to extending the server.
Extend the Server from the Rack
NOTE Ensure that there is enough area (Approximately 1.5 meters [4.5 ft.]) to fully extend the server
out the front and work on it.
To extend the server from the rack, perform the following steps:
Step 1. Remove the T-25 screws that fasten the server to the rack. See Figure 1-2, “Accessing 25MM Torx
Screws.”

HP Integrity rx4640 Specifications

General

Brand	HP
Model	Integrity rx4640
Category	Server
Language	English