Chapter 1
Overview—Server Upgrade
Front and Top Covers
20
Removing the Top Cover
To remove the top cover, perform the following steps:
Step 1. If rack mounted, slide the hp Server out from the rack until it stops. See “Accessing a Rack
Mounted Server” on page 12.
Step 2. Loosen the two captive thumbscrews that hold the top cover in place.
Step 3. Pull the cover toward the rear of the server to free the tabs from the slots in the center of the
chassis and lift it straight up.
Installing the Top Cover
To install the top cover, perform the following steps:
Step 1. Align the tabs at the rear of the top cover with the corresponding slots in the chassis, fully seat the
tabs into the slots, and push forward until it seats.
Step 2. Using a Torx T15 driver, tighten the two thumbscrews securely.
Step 3. If rack mounted, slide the hp Server into the rack until it stops.
To Next Page
Loading...
