Chapter 2
Upgrade Procedures for 1.1 GHz mx2 Dual Processors (A9730A)
Introduction
40
Step 1. Reconnect AC power to rear panel connectors.
Step 2. Press the front panel power switch to power on the server.
Step 3. Wait for completion of the power-on-self-test. Verify that no errors have been detected.
Step 4. At the EFI/OS selection, select the EFI shell and enter the Info CPU command. Verify that all
newly installed processors are recognized and are responding correctly.
PROCESSOR MODULE INFORMATION
# of L3 L4 Family/
CPU Logical Cache Cache Model Processor
Slot CPUs Speed Size Size (hex.) Rev State
---- ------- -------- ------ ------ ------- --- ------------
0 2 1.1 GHz 4 MB None 1F/01 B1 Active
^
Note 2 CPUs' per CPU slot
Step 5. Initiate the OS and monitor operation. Check for error messages. Check the System Event Log for
erroneous system events
To Next Page
Loading...
Need help?
General