Page skew
●
Make sure that the media is loaded correctly and the
media guides are not too tight or too loose against the
media stack.
●
The input bin might be too full.
●
Check the media type and quality.
Curl or wave
●
Check the media type and quality. Both high
temperature and humidity cause media to curl.
●
The media might have been in the input tray too long.
Turn over the stack of media in the tray. Also, try
rotating the media 180° in the input tray.
●
Open the straight-through output door and try printing
straight through.
●
The fuser temperature might be too high. In your printer
driver, make sure the appropriate media type is
selected. If the problem persists, select a media type
that uses a lower fuser temperature, such as
transparencies or light media.
Wrinkles or creases
●
Make sure that media is loaded properly.
●
Check the media type and quality.
●
Open the straight-through output door and try printing
straight through.
●
Turn over the stack of media in the tray. Also, try
rotating the media 180° in the input tray.
● For envelopes, this can be caused by air pockets inside
the envelope. Remove the envelope, flatten the
envelope, and try printing again.
158 Chapter 7 Problem solving ENWW
For more information on the LaserJet P2015 Visit www.PrinterSupplies.com 800-551-1943
To Next Page
Loading...