5. Close the DIMM door.
6. Reconnect all printer cables and cords, and then use the power switch to turn on the printer.
Test the DIMM installation
To test the DIMM installation, print a configuration page, and check the Total Memory specified on
the page.
If all lights on the control panel are blinking, the DIMM installation was unsuccessful. Remove the
DIMM and reinstall it.
Remove a DIMM
To remove a DIMM, follow the instructions below:
CAUTION Handling a DIMM (memory) without wearing a grounded, antistatic device might
damage the DIMM. Touch any metal part of the printer or other grounded metal before
touching the DIMM.
1. Use the power switch to turn off the printer, and then unplug all of the cables and cords
connected to the printer.
256 Appendix A Accessory/Consumable addendum ENWW
For more information on the LaserJet P2015 Visit www.PrinterSupplies.com 800-551-1943
To Next Page
Loading...