NOTE For best results use a sheet of transparency. If you do not have any transparencies,
you can use copier-grade media (70 to 90 g/m
2
(18 to 24 lb.)) with a smooth surface.
1. Make sure that the printer is idle and the Ready light is on.
2. Load the transparency in tray 1.
3. Print a cleaning page using one of the following methods:
●
Open HP ToolboxFX. Click the Troubleshooting tab, and then click Print Quality Tools.
Select the cleaning page.
●
On the printer control panel, press and hold the Go button until the Attention, Ready, and
Go lights come on. When all three lights come on, release the Go button.
●
Press Go again. The printer picks up the transparency and begins the cleaning process.
NOTE The cleaning process takes approximately 2 minutes. The cleaning page will stop
periodically during the cleaning process. Do not turn the printer off until the cleaning process
has finished. You might need to repeat the cleaning process several times to thoroughly clean
the printer.
ENWW Clean the printer 45
For more information on the LaserJet P2015 Visit www.PrinterSupplies.com 800-551-1943
To Next Page
Loading...