4.
Before you proceed
, look at Figure 1-136 Remove the fuser (4 of 8) on page 94. In the
following step, the connector and guide will be separated from the fuser. You must not use too
much force and damage the lower portion of the guide. If the guide is damaged, the fuser must be
replaced.
Figure 1-136 Remove the fuser (4 of 8)
5. Carefully disconnect one connector and rotate the connector and the top portion of the guide
away from the fuser (callout 1).
WARNING! Do not separate the connector and guide more than is shown in Figure 1-136
Remove the fuser (4 of 8) on page 94. If the guide is damaged, you must replace the fuser.
Figure 1-137 Remove the fuser (5 of 8)
1
94 Chapter 1 Removal and replacement ENWW
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...