2. Open the duplex-feed assembly, release one tab (callout 1), and then slightly separate the cover
from the product.
Figure 1-44 Remove the rear-lower cover and rear-door links (duplex product) (2 of 6)
1
3. Release one tab (callout 1) and slightly separate the cover from the product.
Figure 1-45 Remove the rear-lower cover and rear-door links (duplex product) (3 of 6)
1
ENWW
Removal and replacement procedures
35
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...