Index
PCI-X Hot Plug expansion boards front fan cage 2-56
overview 2-35 hot-plug fan 2-40
removing 2-36 media board 2-58
PCI-X Hot Plug expansion slot locations 2-36 memory board 2-23
PCI-X Hot Plug expansion slots, controlling 2-35
pass-through board 2-57
PCI-X non-Hot-Plug expansion slot locations 2-36
PCI-X board 2-54
PCI-X non-hot-plug, expansion board PCI-X expansion board basket 2-53
removing 2-51 rear fan cage 2-59
replacing 2-52 SCSI backplane 2-62
PCI-X retaining clip 2-37
SCSI cables 2-55
PCI-X technology
server from rack 2-13
performance balancing 2-39 ROM Based Setup Utility, described 3-3
slot population 2-39 ROM, troubleshooting 5-10
POST error messages 5-8 ROMPaq Disaster Recovery 5-11
power button/LED assembly, removing and
replacing 2-45
ROMPaq disaster recovery mode, enabling 4-26
ROMPaq Utility, described 3-3
power supply blank, removing and replacing 2-33
power supply, removing and replacing 2-34
S
powering down the server 2-13
SCSI backplane, removing and replacing 2-62
powering up the server 5-2
SCSI cables, removing and replacing 2-55
PPMs See processor power modules
server
preparation procedures
extending from rack 2-6
extending server from rack 2-6
mechanical components 1-3
overview 2-4
powering down 2-13
powering down server 2-13
removing from rack 2-13
removing front access panel 2-10
system components 1-5
removing rear access panel 2-8
warnings and cautions 2-3
removing server from the rack 2-13
single-board mirrored memory LEDs,
identified 2-20
processor air baffle, removing and replacing 2-46
processors, removing 2-49
Single-Board Mirrored Memory Technology,
additional installation requirements 2-23
ProLiant Essentials Foundation Pack,
troubleshooting 5-9
slimline drive bay, removing a drive 2-42
spare part numbers
R
mechanical components 1-3
rack system components 1-5
warnings and cautions 2-2 static electricity, prevention 2-1
rack, extending server 2-6 switches
RBSU See ROM-Based Setup Utility iLO/spread spectrum 4-27
rear access panel internal diagnostic display 4-22
guide marks 2-12 non-maskable interrupt 4-28
removing 2-8 rear unit identification 4-29
rear fan cage, removing and replacing 2-59 system board 4-23
rear panel connectors 4-2 system ID 4-26
removable media board, removing and
replacing 2-58
system maintenance 4-24
symbols on equipment 2-2
removal and replacement procedures system board
hot-pluggable parts 2-30 connectors 4-3
non-hot-pluggable parts 2-41 removing and replacing 2-65
preparation 2-4 switches 4-23
removing system components part numbers 1-5
Battery-Backed Write Cache (BBWC)
assembly 2-60
system components, illustrated 1-4
System Erase Utility 5-9
DIMM 2-25 system ID switch 4-26
HP ProLiant DL580 Generation 2 Server Maintenance and Service Guide Index-3
To Next Page
Loading...
