HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 103
To control local logging (LocalLogEnabled parameter) and remote logging (RemoteLogEnabled and
RemoteLogHostAddress parameters), enter the set setup system command in an Admin session,
as shown in the following example:
8/20q FC Switch (admin) #> set setup system
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
EthNetworkDiscovery (1=Static, 2=Bootp, 3=Dhcp, 4=Rarp) [Static ]
EthNetworkAddress (dot-notated IP Address) [10.0.0.1 ]
EthNetworkMask (dot-notated IP Address) [255.255.255.0]
EthGatewayAddress (dot-notated IP Address) [10.0.0.254 ]
AdminTimeout (dec value 0-1440 minutes, 0=never) [30 ]
InactivityTimeout (dec value 0-1440 minutes, 0=never) [0 ]
LocalLogEnabled (True / False) [True ]
RemoteLogEnabled (True / False) [False ]
RemoteLogHostAddress (dot-notated IP Address) [10.0.0.254 ]
NTPClientEnabled (True / False) [False ]
NTPServerAddress (dot-notated IP Address) [10.0.0.254 ]
EmbeddedGUIEnabled (True / False) [True ]
Creating and downloading a log file
To collect the event log messages in a file (logfile) on the switch, enter the set log archive
command. logfile can have a maximum of 1,200 event messages. Use FTP to download the file from
the switch to your workstation as follows:
1. Log into the switch through Telnet and create an archive of the event log. To create a file on the switch
named logfile, enter the set log archive command.
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> set log archive
2. Open an FTP session on the switch and log in with the account name images and password images.
Transfer the file logfile in binary mode with the get command.
>ftp ip_address
user:images
password: images
ftp>bin
ftp>get logfile
xxxxx bytes sent in xx secs.
ftp>quit
To Next Page
Loading...
Need help?
General