208 Command Reference
set pagebreak
Description Specifies how much information is displayed on the screen at a time. This command is useful for
disabling pagebreaks to allow command scripts to run without interruption.
Authority None
Syntax
pagebreak [state]
Operands
[state]
Table 43 describes the pagebreak state parameters.
Table 43 Pagebreak state parameters
Parameter Description
on Limits the display of information to 20 lines at a time. The page break function
affects the following commands:
• alias (list, members)
• show (alarm, log)
• zone (list, members)
• zoneset (list, zones)
• zoning (active, list)
off Allows continuous display of information without a break. This is the default.
Examples The following is an example of the set pagebreak command:
8/20q FC Switch #> set pagebreak on
8/20q FC Switch #> zone list
Zone ZoneSet
---- -------
Zone1
alpha
beta
Zone2
delta
echo
Zone3
sierra
tango
Zone4
gamma
delta
Press any key to continue, 'q' to quit ...
See also show pagebreak, page 256
To Next Page
Loading...
Need help?
General