HP StorageWorks 8/20q - Zoning Clear

HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 305
zoning clear
Description Clears all inactive zonesets from the volatile edit copy of the zoning database. This operand requires
a zoning edit session. This operand does not affect the non-volatile zoning database. However, if
you enter the zoning clear command followed by the zoning save command, the non-volatile
zoning database will be cleared from the switch.
TIP: The preferred method for clearing the zoning database from the switch is the reset zoning
command.
Authority Admin session and a Zoning Edit session.
Syntax
zoning clear
Examples The following is an example of the zoning clear command:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> zoning edit
8/20q FC Switch (admin-zoning) #> zoning clear
8/20q FC Switch (admin-zoning) #> zoning save
See also zoning save, page 315