HP StorageWorks 8/20q - Clone Config Port

HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 135
clone config port
Description Duplicates a source port configuration on specified target ports.
Authority Admin session and a Config Edit session
Syntax
clone config port
[source_port_number] [port_list]
Operands
[source_port_number] [port_list]
Duplicates the configuration of a port given by [source_port_number] on a set of target
ports given by [port_list]. [source_port_number] can be 0–19. [port_list] can be a list of port
numbers or ranges delimited by spaces.
Notes See Table 33 for a description of the port configuration parameters.
Examples The following example configures ports 8–19 based on port 0:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) config edit
8/20q FC Switch (admin) #> clone config port 0 8-19
Port 0 configuration will be cloned to ports 8-19.
Please confirm (y/n): [n] y
8/20q FC Switch (admin-config)#> config save
8/20q FC Switch (admin)#> config activate
8/20q FC Switch (admin)#> admin end
See also set config port, page 195
show config port, page 235