HP StorageWorks 8/20q - Modifying an SNMP Version 3 User Account

HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 123
Modifying an SNMP version 3 user account
To modify an SNMP version 3 user account, enter the snmpv3user edit command as shown in the
following example:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> snmpv3user edit
A list of SNMPV3 user attributes with formatting and current attribute
values for the specified SNMPV3 user will follow.
Enter a new value OR simply press the ENTER key where-ever allowed to
accept the current value.
If you wish to terminate this process before reaching the end of the list,
press "q" or "Q" and the ENTER OR "Ctrl-C" key to do so.
Username (8-32 chars) : snmpuser1
Group (0=ReadOnly, 1=ReadWrite) [ReadWrite ] : 1
Authentication (True/False) [True ] : f
Do you want to save and activate this setup ? (y/n): [n] y
SNMPV3 user account edited and activated.