To Next Page

To Previous Page

HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 197

Examples The following is an example of the set config port command:

8/20q FC Switch #> admin start

8/20q FC Switch (admin) #> config edit

8/20q FC Switch (admin-config) #> set config port 1

A list of attributes with formatting and current values will follow.

Enter a new value or simply press the ENTER key to accept the current value.

If you wish to terminate this process before reaching the end of the list

press 'q' or 'Q' and the ENTER key to do so.

Configuring Port Number: 1

------------------------

AdminState (1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online]

LinkSpeed (1=1Gb/s, 2=2Gb/s, 4=4Gb/s, 8=8Gb/s, A=Auto) [Auto ]

PortType (GL, G, F, FL, TR ) [GL ]

SymPortName (string, max=32 chars) [Port1 ]

ALFairness (True / False) [False ]

DeviceScanEnable (True / False) [True ]

ForceOfflineRSCN (True / False) [False ]

ARB_FF (True / False) [False ]

InteropCredit (decimal value, 0-255) [0 ]

FANEnable (True / False) [True ]

AutoPerfTuning (True / False) [True ]

MSEnable (True / False) [True ]

NoClose (True / False) [False ]

IOStreamGuard (Enable / Disable / Auto) [Auto ]

PDISCPingEnable (True / False) [True ]

Finished configuring attributes.

This configuration must be saved (see config save command) and

activated (see config activate command) before it can take effect.

To discard this configuration use the config cancel command.

HP StorageWorks 8/20q Command Line Interface Guide

Other manuals for HP StorageWorks 8/20q