HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 213
UserAuthServer Enable (True) or disable (False) this server for user account
authentication. A user authentication RADIUS server requires a secure
management connection (SSL). The default is True.
AccountingServer Enable (True) or disable (False) this server for auditing of activity
during a user session. When enabled, user activity is audited whether
UserAuthServer is enabled or not. The default is False.
The accounting server UDP port number is the ServerUDPPort value
plus 1 (the default is 1813).
Timeout Number of seconds to wait to receive a response from the RADIUS server
before timing out. The default is 2.
Retries Number of retries after the first attempt to establish communication with
the RADIUS server fails. The default is 0.
SignPackets Enable (True) or disable (False) the use of sign packets to protect the
RADIUS server packet integrity. The default is False.
Secret 22-byte ASCII string (1–63 characters) used as a password for
authentication purposes between the switch and the RADIUS server.
Table 48 Server-specific RADIUS server configuration attributes
Attribute Description
Examples The following is an example of the set setup radius common command:
8/20q FC Switch (admin) #> set setup radius common
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the attributes
for the server being processed, press 'q' or 'Q' and the ENTER key to do so.
If you wish to terminate the configuration process completely, press 'qq' or
'QQ' and the ENTER key to so do.
PLEASE NOTE:
-----------
* SSL must be enabled in order to configure RADIUS User Authentication
SSL can be enabled using the 'set setup services' command.
Current Values:
DeviceAuthOrder Local
UserAuthOrder Local
TotalServers 1
New Value (press ENTER to not specify value, 'q' to quit):
DeviceAuthOrder 1=Local, 2=Radius, 3=RadiusLocal :
UserAuthOrder 1=Local, 2=Radius, 3=RadiusLocal :
TotalServers decimal value, 0-5 :
Do you want to save and activate this radius setup? (y/n): [n]