DescriptionItem
Sets unit of time for Path Watch Time—minute, hour, or day.Unit of Path Watch
Time
Specify the interval from when a path gets blocked to when a mirror gets split (suspended).
This value must be within the range of 1 to 59 minutes, 1 to 23 hours, or 1 to 30 days. You
can specify a numeric value in Path Watch Time.
Make sure that the same interval is set to both the master and restore mirrors, unless otherwise
required. If the interval differs between the master and restore mirrors, these mirrors do not
suspend simultaneously. For example, if the interval for the master mirror is 5 minutes and
the interval for the restore mirror is 60 minutes, the master mirror suspends in 5 minutes after
a path gets blocked, and the restore mirror suspends in 60 minutes after a path gets blocked.
IMPORTANT: If you want a mirror to get split (suspended) immediately after a path gets
blocked, ask the HP Technical Support to set system option mode 448 to ON and set system
option mode 449 to OFF.
Path Watch Time
Forwards the Path Watch Time value for the master mirror to the restore mirror, which results
in the same Path Watch Time value for both.
Forward Path Watch
Time
Sets pace for initial copy—Slow, Medium, or Fast.Copy Pace
Line speed of data transfer.Transfer Speed
Sets the processing that takes place when the delta resync operation cannot be
performed—entire P-VOL is copied or no processing (S-VOL not updated).
Delta resync Failure
Applies the settings in the dialog box to the Journal Operation windowSet
Cancels the settings and closes the dialog box.Cancel
Edit Journal Volumes dialog box
This dialog box lets you register or delete journal volumes from a journal. See the following for
complete information:
• “Register journal volumes in a journal ” (page 50)
• “Delete journal volumes from a journal ” (page 87)
158 Continuous Access Journal GUI reference
To Next Page
Loading...
Need help?
General