EasyManuals Logo

HP StoreFabric SN6500B User Manual

HP StoreFabric SN6500B
666 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #100 background imageLoading...
Page #100 background image
100 Fabric OS Administrator’s Guide
53-1002745-02
Enabling and disabling switches
3
FIGURE 4 Blade swap with Virtual Fabrics after the swap
Swapping blades
Use the following procedure to swap blades:
1. Connect to the Backbone and log in using an account with admin permissions.
2. Enter the bladeSwap command.
If no errors are encountered, the blade swap will complete successfully. If errors are
encountered, the command is interrupted and the ports are set back to their original
configurations.
3. Once the command completes successfully, move the cables from the source blade to the
destination blade.
4. Enter the bladeEnable command on the destination blade to enable all user ports.
Enabling and disabling switches
Switches are enabled by default. In some cases, you may need to disable a switch to perform
diagnostics. This ensures that diagnostic activity does not interfere with normal fabric traffic.
Use the following procedure to disable a switch:
1. Connect to the Backbone and log in using an account with admin permissions.
2. Enter the command switchCfgPersistentDisable --setdisablestate.
This sets the switch to the disabled state without actually disabling it. However, on reset, the switch
will be in a disabled state, and will need to be enabled.

Table of Contents

Other manuals for HP StoreFabric SN6500B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP StoreFabric SN6500B and is the answer not in the manual?

HP StoreFabric SN6500B Specifications

General IconGeneral
BrandHP
ModelStoreFabric SN6500B
CategorySoftware
LanguageEnglish

Related product manuals