HP StoreFabric SN6500B User Manual

148 Fabric OS Administrator’s Guide
53-1002745-02
The boot PROM password
5
The following options are available:
4. Enter 3.
5. At the shell prompt, enter the passwd command.
The passwd command only applies to the boot PROM password when it is entered from the
boot interface.
6. Enter the boot PROM password at the prompt, and then reenter it when prompted. The
password must be eight alphanumeric characters (any additional characters are not recorded).
Record this password for future use.
7. Enter th e saveEnv command to save the new password.
8. Reboot the switch by entering the reset command.
Setting the boot PROM password for a Backbone without a recovery
string
This procedure applies to the Brocade DCX, DCX-4S, DCX 8510-4, and DCX 8510-8 Backbones.
On the Brocade DCX Backbone, set the password on the standby CP blade, fail over, and then set
the password on the previously active (now standby) CP blade to minimize disruption to the fabric.
1. Determine the active CP blade by opening a Telnet session to either CP blade, connecting as
admin, and entering the haShow command.
2. Connect to the active CP blade over a serial or Telnet connection and enter the haDisable
command to prevent failover during the remaining steps.
3. Create a serial connection to the standby CP blade as described in “Connecting to Fabric OS
through the serial port” on page 56.
4. Reboot the standby CP blade by sliding the On/Off switch on the ejector handle of the standby
CP blade to Off, and then back to On.
This causes the blade to reset.
5. Press Esc within four seconds after the message
Press escape within 4 seconds... is
displayed.
The following options are available:
6. Enter 3.
7. Enter th e passwd command at the shell prompt.
Option Description
1 Start system. Continues the system boot process.
2 Recovery password. Lets you set the recovery string and the boot PROM password.
3 Enter command shell. Provides access to boot parameters.
Option Description
1 Start system. Continues the system boot process.
2 Recovery password. Lets you set the recovery string and the boot PROM password.
3 Enter command shell. Provides access to boot parameters.

HP StoreFabric SN6500B Specifications

General

Brand	HP
Model	StoreFabric SN6500B
Category	Software
Language	English