Fabric OS Administrator’s Guide 297
53-1002745-02
Changing a logical switch to a base switch
10
Checking and logging message: fid = 5.
Please enable your switch.
sw0:FID128:admin> fosexec --fid 7 -cmd "switchenable"
---------------------------------------------------
"switchenable" on FID 7:
Changing a logical switch to a base switch
Use the following procedure to change a logical switch to a base switch.
1. Connect to the switch and log in using an account with the chassis-role permission.
2. Set the context to the logical switch you want to change, if you are not already in that context.
setcontext fabricID (or switchname)
The fabricID parameter is the FID of the logical switch you want to change to a base switch.
The switchname parameter is the name assigned to the logical switch.
You can only use one parameter at a time.
3. Configure the switch to not allow XISL use, as described in “Configuring a logical switch to use
XISLs” on page 299.
4. Enter the lsCfg command to change the logical switch to a base switch:
lscfg --change fabricID -base
The fabricID parameter is the fabric ID of the logical switch with the attributes you want to
change.
5. Enable the switch.
switchenable
Example of changing the logical switch with FID 7 to a base switch
sw0:FID128:admin> setcontext 7
switch_25:FID7:admin> switchshow
switchName: switch_25
switchType: 66.1
switchState: Online
switchMode: Native
switchRole: Principal
switchDomain: 30
switchId: fffc1e
switchWwn: 10:00:00:05:1e:82:3c:2c
zoning: OFF
switchBeacon: OFF
FC Router: OFF
Fabric Name: MktFab7
Allow XISL Use: ON
LS Attributes: [FID: 7, Base Switch: No, Default Switch: No, Address Mode 0]
(output truncated)
switch_25:FID7:admin> configure
Not all options will be available on an enabled switch.
To disable the switch, use the "switchDisable" command.
To Next Page
Loading...
Need help?
General