EasyManuals Logo

HP StoreFabric SN6500B User Manual

HP StoreFabric SN6500B
666 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #583 background imageLoading...
Page #583 background image
Fabric OS Administrator’s Guide 583
53-1002745-02
Inter-fabric link configuration
24
Refer to the Fibre Channel over IP Administrator’s Guide for instructions on how to configure FCIP
tunnels.
Inter-fabric link configuration
Before configuring an inter-fabric link (IFL), be aware that you cannot configure both IFLs (EX_Ports,
VEX_Ports) and ISLs (E_Ports) from a backbone fabric to the same edge fabric.
Configuring an inter-fabric link involves disabling ports and cabling them to other fabrics,
configuring those ports for their intended uses, and then enabling the ports.
To configure a 16-Gbps IFL, both the EX_Port and the connecting E_Port must be 16-Gbps ports.
ATTENTION
To ensure that fabrics remain isolated, disable the port prior to inserting the cable. If you are
configuring an EX_Port, disable the port prior to making the connection.
Configuring an IFL for both edge and backbone connections
1. On the FC router, disable the port that you are configuring as an EX_Port (the one connected to
the Fabric OS switch) by issuing the portDisable command.
switch:admin> portdisable 7/10
You can verify that the port has been disabled by issuing the portShow command for the port.
2. Configure each port that connects to an edge fabric as an EX_Port or VEX_Port. Note the
following:
• portCfgVEXPort works only on VE_Ports.
• portCfgEXPort (only on the FC ports on the FC router) commands work only on ports that
are capable of FC-FC routing.
Use the portCfgEXPort or portCfgVEXPort command to:
• Enable or disable EX_Port or VEX_Port mode.
• Set the fabric ID (avoid using fabric IDs 1 and 128, which are the default IDs for backbone
connections).
• Configure an EX_Port to connect to a Brocade Network OS fabric (portCfgEXPort only).
The following example configures an EX_Port and assigns a Fabric ID of 30 to port 10.
switch:admin> portcfgexport 7/10 -a 1 -f 30
switch:admin> portcfgexport 7/10
Port 7/10 info
Admin: enabled
State: NOT OK
Pid format: Not Applicable
Operate mode: Brocade Native
Edge Fabric ID: 30
Preferred Domain ID: 160
Front WWN: 50:06:06:9e:20:38:6e:1e
Fabric Parameters: Auto Negotiate
R_A_TOV: Not Applicable
E_D_TOV: Not Applicable
Authentication Type: None
DH Group: N/A

Table of Contents

Other manuals for HP StoreFabric SN6500B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP StoreFabric SN6500B and is the answer not in the manual?

HP StoreFabric SN6500B Specifications

General IconGeneral
BrandHP
ModelStoreFabric SN6500B
CategorySoftware
LanguageEnglish

Related product manuals