46 Fabric OS Administrator’s Guide
53-1002745-02
Management server database
1
If the list is empty (the default), the management server is accessible to all systems connected
in-band to the fabric. For more access security, you can specify WWNs in the ACL so that access to
the management server is restricted to only those WWNs listed.
The management server is logical switch-capable. All management server features are supported
within a logical switch.
Displaying the management server ACL
Use the following procedure to display the management server ACL:
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the msConfigure command.
The command becomes interactive.
3. At the “select” prompt, enter 1 to display the access list.
A list of WWNs that have access to the management server is displayed.
Example of an empty access list
switch:admin> msconfigure
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1] 1
MS Access list is empty.
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1] 0
done ...
Adding a member to the ACL
Use the following procedure to add a member to the ACL:
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the msConfigure command.
The command becomes interactive.
3. At the “select” prompt, enter 2 to add a member based on its port/node WWN.
4. At the “Port/Node WWN” prompt, enter the WWN of the host to be added to the ACL.
5. At the “select” prompt, enter 1 to display the access list so you can verify that the WWN you
entered was added to the ACL.
6. After verifying that the WWN was added correctly, enter 0 at the prompt to end the session.
7. At the “Update the FLASH?” prompt, enter y.
8. Press Enter to update the nonvolatile memory and end the session.
To Next Page
Loading...
Need help?
General