532 Fabric OS Administrator’s Guide
53-1002745-02
Setting QoS zone-based traffic prioritization over FC routers
21
Setting QoS zone-based traffic prioritization over FC routers
1. Connect to the switch in the edge fabric and log in using an account with admin permissions.
2. Create QoS zones in the edge fabric.
The QoS zones must have WWN members only, and not D,I members. See “Setting QoS
zone-based traffic prioritization” on page 530 for instructions.
3. Create LSAN zones in the edge fabric.
See “Controlling device communication with the LSAN” on page 591 for instructions.
4. Enter the portCfgQos command to enable QoS on the E_Ports.
5. Repeat step 1 through step 3 to create QoS zones and LSAN zones on the other edge fabric.
6. Connect to the FC router in the backbone fabric and log in using an account with admin
permissions.
7. Enter th e portCfgQos command to enable QoS on the EX_Ports.
Disabling QoS zone-based traffic prioritization
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the cfgRemove command to remove the QoS zones from the current zone configuration.
3. Enter the portCfgQos command to disable QoS on the E_Ports.
To Next Page
Loading...
Need help?
General