482 Fabric OS Administrator’s Guide
53-1002745-02
Removing a licensed feature
18
Use the following procedure to add a licensed feature:
1. Connect to the switch and log in using an account with admin permissions.
2. Activate the license using the licenseAdd command.
3. Verify the license was added by entering the licenseShow command. The licensed features
currently installed on the switch are listed. If the feature is not listed, enter the licenseAdd
command again.
Some features may require additional configuration, or you may need to disable and re-enable
the switch to make them operational; see the feature documentation for details.
switch:admin> licenseshow
aAYtMJg7tmMZrTZ9JTWBC4SXWLJMY3QfBJYHG:
Fabric license
Remote Switch license
Remote Fabric license
Extended Fabric license
Entry Fabric license
Fabric Watch license
Performance Monitor license
Trunking license
4 Domain Fabric license
FICON_CUP license
High-Performance Extension over FCIP/FC license
Full Ports on Demand license - additional 16 port upgrade license
2 Domain Fabric license
Integrated Routing license
Storage Application Services license
FICON Tape license
FICON XRC license
Adaptive Networking license
Inter Chassis Link license
Enhanced Group Management license
8 Gig FC license
DataFort Compatibility license
Server Application Optimization license
Removing a licensed feature
Use the following procedure to remove a licenced feature:
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the licenseShow command to display the active licenses.
3. Remove the license key using the licenseRemove command.
The license key is case-sensitive and must be entered exactly as given. The quotation marks
are optional. After removing a license key, the licensed feature is disabled when the switch is
rebooted or when a switch disable and enable is performed.
To Next Page
Loading...
Need help?
General