106 Fabric OS Administrator’s Guide
53-1002745-02
Track and control switch changes
3
Flash 0 0
MarginalPorts 0.00%[0] 0.00%[0]
FaultyPorts 0.00%[0] 0.00%[0]
MissingSFPs 0.00%[0] 0.00%[0]
ErrorPorts 0.00%[0] 0.00%[0]
Number of ports: 4
Setting the switch status policy threshold values
Use the following procedure to set the switch status policy threshold values:
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the switchStatusPolicySet command.
The current switch status policy parameter values are displayed. You are prompted to enter
values for each DOWN and MARGINAL threshold parameter.
By setting the DOWN and MARGINAL values for a parameter to 0,0 that parameter is no longer
used in setting the overall status for the switch.
3. Verify the threshold settings you have configured for each parameter.
Enter the switchStatusPolicyShow command to view your current switch status policy
configuration.
Example output from a switch
The following example displays what is typically seen from a Brocade switch, but the quantity and
types vary by platform.
switch:admin> switchstatuspolicyshow
To change the overall switch status policy parameters
The current overall switch status policy parameters:
Down Marginal
-----------------------------------
PowerSupplies 2 1
Temperatures 2 1
Fans 2 1
Flash 0 1
MarginalPorts 25.00%[12] 10.00%[5]
FaultyPorts 25.00%[12] 10.00%[5]
MissingSFPs 0.00%[0] 0.00%[0]
ErrorPorts 0.00%[0] 0.00%[0]
Number of ports: 48
Note that the value, 0, for a parameter, means that it is
NOT used in the calculation.
** In addition, if the range of settable values in the prompt is (0..0),
** the policy parameter is NOT applicable to the switch.
** Simply hit the Return key.
The minimum number of
Bad PowerSupplies contributing to DOWN status: (0..2) [2]
Bad PowerSupplies contributing to MARGINAL status: (0..2) [1]
Bad Temperatures contributing to DOWN status: (0..4) [2]1
Bad Temperatures contributing to MARGINAL status: (0..4) [1]2
To Next Page
Loading...
Need help?
General